MBraun
MBraun UV-Press
On requestMBraun
The MBraun MB UV-Press bonds and hermetically seals sensitive samples (e.g. OLEDs, perovskite or battery cells) under inert gas – fully integrated into your glovebox, with no oxygen or moisture contact. Bonding and UV curing happen in a single step, right where the samples are made. The unit is used but was rarely operated and has not been in use for the past few years.
Specifications
| Manufacturer | MBraun |
| Model | MB UV-Press |
| Function | Sample encapsulation (bonding + UV curing) inside the glovebox |
| UV lamp | Dymax, 400 W, filtered cold light |
| Light intensity | 105–225 mW/cm² |
| Cure time | under 3 seconds |
| Substrate size | up to 203.2 × 203.2 mm |
| Sandwich height | 0.7–1.1 mm |
| Pressure | vacuum chuck + pneumatic drive, controlled via gauge & manual valve |
| Control | Siemens KTP400 operator panel |
| Condition | Used, rarely operated – manuals available |
| Viewing | on site possible |
The process in three steps1. Manually load the sample between the substrate and cover glass. 2. Bonding with vacuum or mechanical pressure – the glass plates are brought together evenly and pressed via a vacuum chuck and pneumatic drive. 3. Curing – the adhesive is cured by UV lamp in under 3 seconds.
Highlights & benefits
- Bonding & sealing in a single step
- Fully integrated into the glovebox – no O₂/moisture contact
- Dymax UV lamp (400 W), filtered cold light – minimal heat
- Extremely short, reproducible exposure times (< 3 s)
- Precise pressure control via vacuum chuck & gauge
- Convenient control via KTP400 operator panel